Norinco mak 90 top cover replacement
Remove ALL furniture from your AK if you like the finish on it, you are better off safe than sorry. 12ton shop press (I got mine at harbor frieght for $100 w/ a coupon)
NORINCO MAK 90 TOP COVER REPLACEMENT DRIVER
Quality screw driver set for removing furniture Sorry for the crappy MSpaint drawing but it's the best I can do for nowĭon't mind the extra hole or weird cut, I'm working on another part of the jig Once the barrel will slip in you are done, now you can "clamp" the jig onto the barrel, after the FSB, and make sure that it fits tightly but slides freely.
Slowly and carefully drill the hole making sure it stays straight, pull the dirll bit out and clean off shavings as needed, becareful as aluminum is soft and if the shavings build it up it could ruin the hole you are drilling.Īfter you have completed drilling the hole, seperate the 2" pice and 1" piece, you will need to file off the edge on the 2" piece of barstock so the barrel will slip in, take your time and use the barrel as a guide as to when to stop filing. Measure 2" from end of barstock and 1 13/16" from top, this is where you will drill you 5/8" hole, it should have the majority of the opening on the piece of 2" barstock and a sliver on the 1" piece of bar stock. Use screws to hold pieces of barstock together firmly and place back in vice. To start you will tape the 2 piece of barstock together so all sides are flush, put the 2 pieces in a vice so they are held together side by side.ĭrill a hole 1/2" from both ends (as see in red) going through the 1" piece and 2" piece of barstock. Metal file, you will need a fine tooth file a coarse one will work but be alittle more carefulġ/4"x20x4" screw, 4 washers and 4 wing nuts
2 Pieces of aluminum barstock (steel would work but you will mostlikely burn through drill bits) (1-2"x1"x8" and 1- 1"x1"x8")